CLI Guide

Dell EMC Networking CLI 186
OSPF
ipv6 pim rp-address Statically configures the Rendezvous Point (RP)
address for one or more multicast groups.
GC
ipv6 pim rp-candidate Configures the router to advertise itself as a
PIM candidate rendezvous point (RP) to the
bootstrap router (BSR).
GC
ipv6 pim sparse-mode Administratively configures PIM sparse mode
for multicast routing.
GC
ipv6 pim ssm Defines the Source Specific Multicast (SSM)
range of multicast addresses.
GC
show ipv6 pim Displays global status of IPv6 PIMSM and its
IPv6 routing interfaces.
PE or
GC
show ipv6 pim bsr-router Display the bootstrap router (BSR)
information.
UE,
PE, or
GC
show ip mroute group Displays the multicast configuration settings PE
show ip mroute source Displays the multicast configuration settings PE
show ipv6 pim interface Displays interface config parameters. PE or
GC
show ipv6 pim neighbor Displays IPv6 PIMSM neighbors learned on the
routing interfaces.
PE or
GC
show ipv6 pim rp-hash Displays which rendezvous point (RP) is being
selected for a specified group.
PE or
GC
show ipv6 pim rp mapping Displays all group-to-RP mappings of which the
router is aware (either configured or learned
from the bootstrap router (BSR).
PE or
GC
a. For the meaning of each Mode abbreviation, see Mode Types .
Command Description Mode
a
area default-cost (Router
OSPF)
Configures the advertised default cost for the
stub area.
ROSPF
Command Description Mode
a