CLI Guide

Layer 3 Routing Commands 1908
console(config-if-vrrp)#timers advertise 50
shutdown
Use the shutdown command to disable a Virtual Router Redundancy Protocol
version 3 (VRRPv3) group configuration.
Syntax
shutdown
no shutdown
Default Configuration
VRRPv3 Groups are disabled by default.
Command Mode
VRRPv3 Group Configuration mode
User Guidelines
Use the no shutdown command to update the virtual router state after
completing configuration.
Command History
Command introduced in version 6.6 firmware.
Example
The following example shows how to enable a VRRP group:
console(config-if-vrrp)#no shutdown
address
Use this command to set the primary or secondary IP address of the switch
within a Virtual Router Redundancy Protocol version 3 (VRRPv3) group. To
remove the secondary address, use the no form of this command.
Syntax
address ip-address [primary | secondary]