CLI Guide

Switch Management Commands 2099
Command History
Description revised in 6.3.5 release. Command updated in firmware release
6.6.1.
power inline management
Use the power inline management command in Global Configuration mode
to set the power management type. Use the no form of this command to set
the management mode to the default.
Syntax
power inline management [unit unit-id]{dynamic | static | class}
no power inline management [unit unit-id]
• dynamic—Dynamic power management
• static—Static power management
• class—Class-based power management
• unit-id—A stack unit ID.
Default Configuration
Default management is dynamic.
Command Mode
Global Configuration
User Guidelines
The N2200PX-ON switches only support power inline management dynamic
or power inline management class configuration. When class-based
management is enabled on these switches, IEEE 802.3bt autoclass is also
enabled. PDs implementing autoclass may draw less than the class limit at
maximum power. The excess power is available for use by other PDs.
If no unit is specified, all members of the stack are configured. Static,
dynamic and class-based modes differ in how the available power is calculated
and how much power may be delivered to the Powered Device. Refer to the
PoE section in the User’s Configuration Guide for information on Powered
Device detection, power allocation methods, and the PoE guard band.