CLI Guide

Dell EMC Networking CLI 212
sFlow
exception switch-chip-
register
Enables the dumping of the switch chip
registers in case of an exception.
GC
ip http timeout-policy Configures the timeout policy for closing HTTP
and HTTPS sessions to the local HTTP server.
GC
show debugging Displays packet tracing configurations. PE
show exception Displays the core dump configuration
parameters, the current or previous exception
log, or the core dump file listing.
PE
show supported mibs Displays the internal message queue
allocations.
PE,
GC
show supported mibs Displays the HTTP server status and
configuration.
PE,
GC
show supported mibs Displays the implemented SNMP MIBs. PE,
GC
snapshot bgp Dumps a set of BGP debug information to
capture the current state of BGP.
S
write core Generates a core file on demand and either,
reboots the switch or tests the core file
configuration.
PE
a. For the meaning of each Mode abbreviation, see Mode Types .
Command Description Mode
a
sflow destination Configures sFlow collector parameters (owner
string, receiver timeout, ip address, and port).
GC
sflow polling Enables a new sflow poller instance for the data
source if rcvr_idx is valid.
GC
sflow polling (Interface
Mode)
Enable a new sflow poller instance for this data
source if rcvr_idx is valid.
IC
sflow sampling Enables a new sflow sampler instance for this
data source if rcvr_idx is valid.
GC
Command Description Mode
a