CLI Guide

Switch Management Commands 2143
debug ip acl
Use the debug ip acl command to enable debug of IP Protocol packets
matching the ACL criteria. Use the “no” form of this command to disable IP
ACL debugging.
Syntax
debug ip acl acl
no debug ip acl acl
• acl — The number of the IP ACL to debug.
Default Configuration
Display of IP ACL traces is disabled by default.
Command Mode
Privileged Exec mode.
User Guidelines
Debug output should be enabled with caution. Switch behavior may be
adversely affected by the additional processing load incurred from enabling
debug.
Example
console#debug ip acl 1
debug ip bgp
To enable debug tracing of BGP events, use the debug ip bgp command. To
disable debug tracing, use the no form of this command.
Syntax
debug ip bgp [vrf vrf-name] [ipv4-address | ipv6-address [interface interface-
id]]| events | keepalives | notification | open | refresh | updates | in | out]
no debug ip bgp [ipv4-address | ipv6-address [interface interface-id] | events
| keepalives | notification | open | refresh | updates | in | out]
• interface-id—A routing interface identifier (VLAN interface).