CLI Guide

Switch Management Commands 2153
Example
console#debug ipv6 mld packet
debug ipv6 ospfv3 packet
Use the debug ipv6 ospfv3 packet command to enable debug tracing of IPv6
OSPFv3 packets.
Syntax
debug ipv6 ospfv3 packet
no debug ipv6 ospfv3 packet
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode.
User Guidelines
Debug output should be used with caution. Switch behavior may be adversely
affected by the additional processing load incurred from enabling debug
output. Use of debug-level logging when performing operations such as
switch failover is not recommended.
Debug messages are sent to the system log at the DEBUG severity level. To
print them on the console, enable console logging at the DEBUG level
(logging console debug).
Command History
Command introduced in firmware release 6.6.1.
debug ipv6 pimdm
Use the debug ipv6 pimdm command to trace PIMDMv6 packet reception
and transmission. The receive option traces only received PIMDMv6 packets
and the transmit option traces only transmitted PIMDMv6 packets. When
neither keyword is used in the command, then all PIMDMv6 packet traces are
dumped. Vital information such as source address, destination address,