CLI Guide

Switch Management Commands 2158
• vrf-name—The name of the VRF associated with the routing table
context used by the command. If no vrf is specified, the global routing
table context is used.
Default Configuration
Display of OSPF traces is disabled by default.
Command Mode
Privileged Exec mode.
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
Only IPv4 addresses are supported with the vrf parameter.
This command is only available on the N3000-ON/N3100 switches.
Debug output should be enabled with caution. Switch behavior may be
adversely affected by the additional processing load incurred from enabling
debug.
Example
console#debug ospf packet
debug ospfv3 packet
Use the debug ospfv3 packet command to enable tracing of OSPFv3 packets
received and transmitted by the switch. Use the no form of this command to
disable tracing of OSPFv3 packets.
Syntax
debug ospfv3 packet
no debug ospfv3 packet
Default Configuration
Display of OSPFv3 traces is disabled by default.