CLI Guide

Switch Management Commands 2226
Default Configuration
By default, the switch uses the assigned switch IP address as the source IP
address for SNMP packets. This is either the IP address assigned to the VLAN
from which the SNMP packet originates or the out-of-band interface IP
address.
Command Mode
Global Configuration
User Guidelines
The source interface must have an assigned IP address (either manually or via
another method such as DHCP). This command is not supported on Dell
EMC N1100-ON switches. Dell EMC N1100-ON switches support
configuration of a single IP address in interface vlan configuration mode.
That IP address is used as the source interface address for this function.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#interface vlan 1
console(config-if-vlan1)#ip address dhcp
console(config-if-vlan1)#exit
console(config)#snmp-server source-interface vlan 1