CLI Guide

Switch Management Commands 2237
support-assist
Use the support-assist command to enable support-assist configuration mode
if the EULA has been accepted. Use the no form of the command to remove
the configured SupportAssist information.
Syntax
support-assist
no support-assist
Default Configuration
By default, a server named “default” is configured. It may be disabled by the
administrator.
Command Mode
Global Configuration
User Guidelines
This command enters support-assist-conf mode. It allows the administrator
to configure SupportAssist information. The configured information is stored
in the running config. Use the write command to save the information into
the startup-config.
Command History
Introduced in version 6.3.0.1 firmware.
Examples
Example 1
In this example, the SupportAssist EULA has been accepted.
console(config)#support-assist
console(conf-support-assist)#
Example 2
In this example, the SupportAssist EULA has been rejected.
console(config)#support-assist