CLI Guide

Switch Management Commands 2254
– [6 | informational]
– [7 | debugging]
Default Configuration
The default logging monitor severity level is not configured. By default,
logging messages are not displayed on SSH or telnet sessions (no logging
monitor). Logging messages are displayed by default on console sessions
(serial and out-of-band ports).
Command Mode
Global Configuration mode
User Guidelines
Use the terminal monitor command to enable the asynchronous display of
system messages within an individual telnet or SSH session. Use the logging
monitor command to globally configure the severity of logged messages
within all telnet/SSH sessions. Messages logged telnet and SSH sessions are
filtered based on severity. Selecting a severity level will log that severity and
higher (numerically lower) level messages.
logging on
Use the logging on command in Global Configuration mode to control error
messages logging. This command globally enables the sending of logging
messages to the currently configured locations. To disable the sending of log
messages, use the no form of this command.
Syntax
logging on
no logging on
Default Configuration
Logging is enabled.