CLI Guide

Switch Management Commands 2258
Syntax
logging source-interface {loopback loopback-id} | {tunnel tunnel-id} |
{vlan vlan-id} | {out-of-band }
no logging source-interface
• loopback-id — The name of a loopback interface.
• tunnel-id — The name of a tunnel-id.
• vlan-id —A VLAN identifier.
• out-of-band —The out-of-band interface identifier.
Default Configuration
By default, the switch uses the assigned switch IP address. This is either the
IP address assigned to VLAN or the out-of-band interface IP address.
Command Mode
Global Configuration
User Guidelines
This command is not supported on Dell EMC N1100-ON switches. Dell
EMC N1100-ON switches support configuration of a single IP address in
interface vlan configuration mode. That IP address is used as the source
interface address for this function..
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#interface vlan 1
console(config-if-vlan1)#ip address dhcp
console(config-if-vlan1)#exit
console(config)#logging source-interface vlan 1