CLI Guide

Switch Management Commands 2282
load-interval
Use this command to load the interface utilization measurement interval.
Use the no form of this command to reset the duration to the factory default
value.
Syntax
load-interval time
no load-interval
• time—The number of seconds after which interface utilization is
measured periodically. The time has to be a multiple of 30. (Range 30-
600 seconds)
Default Configuration
The default interval is 300 seconds.
Command Modes
Interface Configuration mode, Interface Range Configuration mode, Port
Channel Configuration mode, Port Channel Range Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config-if-Gi1/0/1)#load-interval 150
locate
Use the locate command to locate a switch by LED blinking.
Syntax
locate [switch unit ] [time time ]
• switch unit—If multiple devices are stacked, you can choose which
switch to identify.
• time time —LED blinking duration in seconds. Range 1-3600 seconds.