CLI Guide

Switch Management Commands 2283
Default Configuration
Default value is 20 seconds.
Command Mode
Privileged Exec
User Guidelines
When this command is executed on N1100-ON/N1500/N2000/N2100-
ON/N2200-ON/N3000-ON/N3100-ON switches, the front panel power
supply 1 LED blinks.
The LED blinks until it times out. The user may select a new time value
while the LED is blinking. The last value selected takes effect immediately.
The locate command does not persist across reboots.
Example
console# locate switch 1 time 555
logout
Use this command to disconnect the serial connection to the remote unit on
the stack member.
Syntax
logout
Default Configuration
There is no default configuration for this command.
Command Modes
User Exec mode on the stack master. Unit prompt on the stack member.
User Guidelines
This command is available in User Exec mode on the master unit serial port
and from the Unit prompt on member unit serial ports. The user need not be
currently connected over the serial port to connect to another unit.