CLI Guide

Switch Management Commands 2286
Command Mode
Global Configuration
User Guidelines
Use the show memory cpu command to display the allocated and free
memory.
Setting the threshold to 0 disables low memory notifications.
The traps and SYSLOG messages are suppressed if they occur more
frequently than once a minute.
Command History
Introduced in version 6.2.0.1 firmware.
Example
This example sets the notification for low memory at 1 megabyte. A notice
message and trap will be issued if free memory falls below 1M and another
notice message and trap will be issued when free memory rises above 1M.
console(config)#memory free low-watermark processor 1000
nsf
Use this command to enable non-stop forwarding. The no form of the
command will disable NSF.
Syntax
nsf
no nsf
Default Configuration
Non-stop forwarding is enabled by default.
Command Mode
Stack Configuration mode