CLI Guide

Switch Management Commands 2295
User Guidelines
The switch logs a message and generates a trap on inserting or removing an
optics not qualified by Dell. This command suppresses the above mentioned
behavior.
Example
The following example bypasses logging of a message and trap generation on
inserting or removing an optics not qualified by Dell.
console(config)# service unsupported-transceiver
set description
Use the set description command in Stack Configuration mode to associate a
text description with a switch in the stack.
Syntax
set description unit description
• unit — The switch identifier. (Range: 1–12)
• description — The text description. (Range: 1–80 alphanumeric
characters)
Default Configuration
This command has no default configuration.
Command Mode
Stack Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays
console(config)#stack
console(config-stack)#set description 1 “unit 1"