CLI Guide

Switch Management Commands 2345
1 6.0.0.1 5.1.0.1 6.0.0.1 5.1.0.1
console#show version 2
SOC Version....................... BCM56842_B1
HW Version........................ 1
CPLD Version...................... 14
Boot Version...................... v1.0.21
Unit Image 1 Image 2 Current Active Next Active
----- ------------ ------------ ----------------- -----------------
2 6.0.0.1 5.1.0.1 6.0.0.1 6.0.0.1
stack
Use the stack command in Global Configuration mode to enter Stack
Configuration mode.
Syntax
stack
Default Configuration
This command has no default mode.
Command Mode
Global Configuration mode
User Guidelines
If no stack configuration appears in the saved config, it is built at runtime and
appears in the running config. The operator can save the stack configuration.
Switches that do not match the saved config (are of a different type than as
configured) after a reboot will show a config mismatch and do not join the
stack. Units that do not join the stack will show their interfaces as detached.
Example
The following example sets the console command mode to Stack Config.
console(config)#stack
console(config-stack)#