CLI Guide

Switch Management Commands 2351
Example
The following example displays how to reconfigure switch number “1” to an
identifier of “2.”
console(config)#switch 1 renumber 2
telnet
Use the telnet command to log into a host that supports Telnet.
Syntax
telnet {ip-address | hostname} [port] [keyword1......]
• ip-address—Valid IP address of the destination host.
• hostname—Hostname of the destination host. (Range: 1–158
characters).
• port—A decimal TCP port number.
• keyword—One or more keywords from the keywords table in the user
guidelines (see Keywords Table below).
Keywords Table
Default Configuration
port — Telnet TCP port (decimal 23) on the host.
Command Mode
User Exec, Privileged Exec mode
Options Description
/debug Enable telnet debugging mode.
/line Enable telnet linemode.
/localecho Enable telnet localecho.
<cr> Press ENTER to execute the command.
port Enter the TCP port number.