CLI Guide

Switch Management Commands 2360
Command History
Examples updated in 6.4 release.
Commands in this Section
This section explains the following commands:
ip telnet server disable
The ip telnet server disable command is used to enable/disable the Telnet
service on the switch.
Syntax
ip telnet server disable
no ip telnet server disable
Command Mode
Global Configuration
User Guidelines
No specific guidelines.
Default Value
This feature is enabled by default.
Dell EMC Networking N-Series switches support the Telnet service over IPv4
and IPv6.
Example
console#configure
console(config)#ip telnet server disable
console(config)# no ip telnet server disable
ip telnet server disable show ip telnet
ip telnet port
–