CLI Guide

Layer 2 Switching Commands 409
---------- ------------------- -------- -------- --------
1129 osapiTimer 0.00% 0.00% 0.01%
1133 _interrupt_thread 0.09% 0.01% 0.00%
1137 bcmCNTR.0 0.24% 0.31% 0.31%
1142 bcmRX 23.00% 27.01% 18.01%
1147 ipMapForwardingTas 32.97% 37.11% 29.92%
1155 bcmLINK.0 0.34% 0.36% 0.36%
1156 cpuUtilMonitorTask 0.09% 0.05% 0.04%
1170 nim_t 0.09% 0.08% 0.07%
1208 dot1s_timer_task 0.00% 0.00% 0.01%
1222 snoopTask 0.00% 0.00% 0.01%
1291 RMONTask 0.00% 0.02% 0.03%
1293 boxs Req 0.00% 0.01% 0.01%
------------------------------ -------- -------- --------
Total CPU Utilization 27.31% 28.97% 31.01%
show interfaces
Use the show interfaces command to list the traffic statistics for one or
multiple interfaces. If no parameter is given, all interfaces are shown.
Syntax
show interfaces [ interface-id ]
• interface-id—An Ethernet interface id (for example, a 1G interface) in
standard interface format.
Default Configuration
There is no default configuration.
Command Mode
All modes, including Config mode and all config submodes.
User Guidelines
The show interface command shows the actual operational status of the
interface, which is not necessarily the same as the configuration.
Input/output rate statistics are collected every 10 seconds.