CLI Guide

Layer 2 Switching Commands 425
Example
The following example displays the status for all configured interfaces.
console(config-if-Po1)#show interfaces status
Port Description Duplex Speed Neg Link Flow M VLAN
State Ctrl
--------- --------------- ------ ------- ---- ------ ----- - ---------------
Gi1/0/1 N/A Unknown Auto Down Off A 1
Gi1/0/2 N/A Unknown Auto Down Off T (11),1,3,5,7,9
15,19,25-4093
Gi1/0/3 N/A Unknown Auto Down Off A 1
Gi1/0/4 N/A Unknown Auto Down Off G (1),2,4,6,8,10
14,16,20,22,24
Gi1/0/5 N/A Unknown Auto Down Off A 1
Gi1/0/6 N/A Unknown Auto Down Off A 1
Gi1/0/7 N/A Unknown Auto Down Off A 1
Gi1/0/8 N/A Unknown Auto Down Off A 1
Gi1/0/9 N/A Unknown Auto Down Off A 1
Oob Type Link
State
--- ------------------------------ -----
oob Out-Of-Band Up
Port Description Link M VLAN
Channel State
------- ------------------------------ ------- - -------------------
Po1 Detach H (4),5
Mode VLAN
A – Access Native
T – Trunk (Native),List
D – Dot1q tunnel Outer
P – Private VLAN
Promiscuous
(Primary), Secondary List
H–Private VLAN Host (Primary), Secondary
G– General (PVID), All the tagged and untagged VLANs.