CLI Guide

Layer 2 Switching Commands 433
show storm-control
Use the show storm-control command to display the configuration of storm
control.
Syntax
show storm-control [all | {gigabitethernet unit/slot/port |
tengigabitethernet unit/slot/port | fortygigabitethernet unit/slot/port}]
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Examples
The following example shows storm control configurations for a Gigabit
Ethernet port. The second example shows flow control mode status.
console#show storm-control
802.3x Flow Control Mode....................... Disable
console#show storm-control gigabitethernet 1/0/1
Bcast Bcast Mcast Mcast Ucast Ucast Flow
Intf Mode Level Mode Level Mode Level Ctrl
---------- -------- --------- -------- --------- -------- --------- --------
Gi1/0/1 Disable 5 Disable 5 Disable 5 Disabled
switch-top(config)#show storm-control all
Bcast Bcast Mcast Mcast Ucast Ucast Flow
Port Mode Level Mode Level Mode Level Ctrl
---------- -------- --------- -------- --------- -------- --------- --------
Gi1/0/1 Enable 90 Enable 5 Enable 10 Enabled