CLI Guide

Layer 2 Switching Commands 440
Example
The following example assigns the name “protected” to group 1.
console(config)#switchport protected 1 name protected
show switchport protected
Use the show switchport protected command to display the status of all the
interfaces, including protected and unprotected interfaces.
Syntax
show switchport protected groupid
• groupid — Identifies which group the port is to be protected in.
(Range: 0–2)
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Example
The following example identifies test as the protected group.
console#show switchport protected 0
Name......................................... test
show system mtu
Use the show system mtu command to display the configured MTU. The
MTU is set using the global system jumbo mtu command. This command
deprecates the show interfaces mtu command.