CLI Guide

Layer 2 Switching Commands 462
no non-revertive
Default Configuration
The default operational mode is revertive.
Command Mode
Ethernet Ring Profile Configuration mode
User Guidelines
Two operational modes are supported: revertive and non-revertive. In
revertive mode, when all failures in the link are removed, traffic is restored to
the working transport entity and the Ring Protection Link (RPL) is blocked.
In non-revertive mode, the RPL continues to be used for traffic, even after all
switch conditions have been resolved.
Example
This example sets non-revertive mode for profile1.
console (config)# ethernet ring g8032 profile profile1
console (config-erp-profile1)#non-revertive
Command History
Command introduced in firmware release 6.6.1.
This command enables non-revertive mode for an Ethernet ring profile. Use
the no form of the command to reset the profile to revertive mode.
ethernet ring g8032
This command creates an Ethernet ring and enters Ethernet Ring
Configuration mode. Use the no form of the command to delete an Ethernet
ring.
Syntax
ethernet ring g8032 ring-name
no ethernet ring g8032 ring-name