CLI Guide

Layer 2 Switching Commands 473
console (config-if-Te1/0/2)#ethernet tcn-propagation g8032 to g8032
Command History
Command introduced in firmware release 6.6.1.
aps-channel
Use the aps-channel command to enter into Ethernet Ring Protection APS-
channel Configuration mode. Use the exit command to exit the APS-
Channel Configuration mode.
Syntax
aps-channel
Default Configuration
This command has no default configuration.
Command Mode
Ethernet Ring Instance Configuration mode
User Guidelines
This command enters into Ethernet Ring Protection APS-channel
Configuration mode. The APS VLAN and CFM message level are specified in
Ethernet Ring Protection APS-channel Configuration mode.
Example
This example configures a closed ring node for interface Te1/0/1 and Te1/0/2
using data VLANs 101-103. It assumes that VLANs 100-103 are already
created. A single instance is created and associated with ERP profile1. The
profile sets the hold-off timer to 500 milliseconds. Interface Te1/0/2 is
configured in the Owner role. Interface Te1/0/2 connects to an adjacent
switch port Te1/0/1. Traffic is blocked on these two ports under normal
conditions. VLANs 101-103 are protected. VLAN 100 is used as the
Automatic Protection Switching (APS) VLAN. Only Ethernet CFM messages
at maintenance level 7 are monitored.
console (config)#vlan 100-103
console (config-vlan100-103)#exit