CLI Guide

Layer 2 Switching Commands 474
console (config)#interface te1/0/1
console (config-if-Te1/0/1)#switchport mode trunk
console (config-if-Te1/0/1)#interface Te1/0/2
console (config-if-Te1/0/2)#switchport mode trunk
console (config-if-Te1/0/2)#exit
console (config)# ethernet ring g8032 ring1
console (config-erp-ring1)#port0 interface te1/0/1
console (config-erp-ring1)#port1 interface te1/0/2
console (config-erp-ring1)#instance 1
console (config-erp-inst-1)#rpl port1 owner
console (config-erp-inst-1)#inclusion-list vlan-ids 101-103
console (config-erp-inst-1)#aps-channel
console (config-erp-inst-1-aps)#level 7
console (config-erp-inst-1-aps)#raps-vlan 100
Command History
Command introduced in firmware release 6.6.1.
level
Use the level command to select the maintenance level of Continuity Check
Messages (CCMs) to be monitored. Use the no form of the command to
remvoe the level selection.
Syntax
level level-id
no level level-id
• level-id —The maintenance level of the CCMs to be monitored. Range 0
to 7.
Default Configuration
This command has no default configuration.
Command Mode
Ethernet Ring Instance Configuration APM mode