CLI Guide

Layer 2 Switching Commands 578
ipv6 mld snooping vlan mrouter
This command statically configures a port as connected to a multicast router
for a specified VLAN. The no form of this command removes the static
binding.
Syntax
ipv6 mld snooping vlan vlan-id mrouter interface interface
no ipv6 mld snooping vlan vlan-id mrouter interface interface
• vlan-id — A VLAN identifier (Range 1-4093).
• interface-id— The next-hop interface to the multicast router.
Default Configuration
There are no multicast router ports configured by default.
Command Mode
Global Configuration mode.
User Guidelines
MLD snooping will forward IPv6 multicast data packets in the VLAN if a
static mrouter port is configured. This behavior can be used to ensure that
MLD snooping will selectively forward IPv6 multicast data traffic even if no
dynamically discovered IPv6 multicast router has been discovered.
Example
console(config)#ipv6 mld snooping vlan 10 mrouter interface Gi1/0/2
ipv6 mld snooping (Global)
Use the ipv6 mld snooping (Global) command to globally enable MLD
Snooping on the system (Global Configuration Mode). Use the no form of
the command to disable MLD snooping.
Syntax
ipv6 mld snooping [vlan vlan-id]
no ipv6 mld snooping [vlan vlan-id]