CLI Guide

Layer 2 Switching Commands 587
ipv6 mld snooping querier election participate
Use the ipv6 mld snooping querier election participate command to enable
the Snooping Querier to participate in the Querier Election process when it
discovers the presence of another Querier in the VLAN. Use the no form of
this command to disable election participation on a VLAN.
Syntax
ipv6 mld snooping querier election participate vlan-id
no ipv6 mld snooping querier election participate vlan-id
• vlan-id — A VLAN identifier (Range: 1 - 4093)
Default Configuration
Election participation is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
When enabled, if there is another querier in the network and the local querier
is in election mode, then the querier with the lower IP address is elected and
the other querier stops querying. If the local querier is not in election mode
and another querier is detected, the local querier stops querying.
Example
console(config-vlan)#ipv6 mld snooping querier election participate 10
ipv6 mld snooping querier query-interval
Use the ipv6 mld snooping querier query-interval command to set the MLD
Querier Query Interval time. Use the no form of this command to reset the
Query Interval to the default.
Syntax
ipv6 mld snooping querier query-interval interval
ipv6 mld snooping querier query-interval