CLI Guide

Layer 2 Switching Commands 613
lldp med faststartrepeatcount
This command is used to set the value of the fast start repeat count.
Syntax
lldp med faststartrepeatcount count
no lldp med faststartrepeatcount
• count — Number of LLDPPDUs that are transmitted when the protocol is
enabled. (Range 1–10)
Command Mode
Global Configuration
Default Value
3
User Guidelines
No specific guidelines.
Example
console(config)# lldp med faststartrepeatcount 2
lldp med-tlv-select
This command is used to specify which optional TLVs in the LLDP MED set
are transmitted in the LLDPDUs. There are certain conditions that have to
be met for a port to be MED compliant. These conditions are explained in
the normative section of the ANSI/TIA-1057 specification. For example, the
MED TLV 'capabilities' is mandatory. By disabling transmission of the MED
capabilities TLV, MED is effectively disabled on the interface.
Syntax
lldp med-tlv-select [capabilities] [network-policy] [ex-pse] [ex-pd]
no lldp med-tlv-select [capabilities] [network-policy] [ex-pse] [ex-pd]