CLI Guide

Layer 2 Switching Commands 808
console(config)#show spanning-tree uplinkfast
Directlink rapid convergence is enabled
BPDU update rate : 150 packets/sec
Directlink rapid convergence Statistics
---------------------
Directlink rapid convergence transitions (all VLANs).. 0
Proxy multicast addresses transmitted (all VLANs)..... 0
Name Interface list
--------------- ------------------------------------
VLAN0001 Gi1/0/2(fwd)
VLAN0002
VLAN0003
VLAN0004
VLAN0005
VLAN0006
VLAN0007
VLAN0008
VLAN0009
VLAN0010
console(config)#show spanning-tree backbonefast
Indirectlink rapid convergence is enabled
Indirectlink rapid convergence Statistics
---------------------
Transitions via indirectlink rapid convergenc.. 0
Inferior BPDUs received (all VLANs)............ 7
RLQ request PDUs received (all VLANs).......... 0
RLQ response PDUs received (all VLANs)......... 0
RLQ request PDUs sent (all VLANs).............. 0
RLQ response PDUs sent (all VLANs)............. 0
This example shows spanning-tree configured in mstp mode. Output is
shown for each VLAN that is a member of an MST domain.
console(config-mst)#show spanning-tree active
Spanning Tree: Enabled (BPDU Flooding: Disabled)
Mode: rstp Portfast BPDU Filtering: Disabled
CST Regional Root: 80:00:00:1E:C9:DE:D4:47
Regional Root Path Cost: 0