Setup Guide

入門指南 95
註：若已設定之，預設的存取層級會設定為 SNMP 管理介面的最高可用存取
層級。一開始只會啟用 SNMPv2。在您返回設定 SNMPv3 的安全性存取 ( 例
如引擎 ID、檢視等等 ) 之前，SNMPv3 都會持續停用。
Please enter the IP address of the Management System (A.B.C.D) or wildcard
(0.0.0.0) to manage from any Management Station.[0.0.0.0]: 10.1.2.100
Step 2:
Now we need to set up your initial privilege (Level 15) user account.This
account is used to login to the CLI and Web interface.You may set up other
accounts and change privilege levels later.For more information on setting up
user accounts and changing privilege levels, see the user documentation.
To set up a user account:
Please enter the user name.[root]:admin
Please enter the user password: ********
Please reenter the user password: ********
Step 3:
Next, an IP address is set up on the VLAN 1 routing interface.
You can use the IP address to access the CLI, Web interface, or SNMP
interface of the switch.
To access the switch through any Management Interface you can
。 Set up the IP address for the Management Interface.
。 Set up the default gateway if IP address is manually configured on the
routing interface.
Step 4:
Would you like to set up the VLAN1 routing interface now?[Y/N] y
Please enter the IP address of the device (A.B.C.D) or enter “DHCP”
(without the quotes) to automatically request an IP address from the network
DHCP server: 10.1.1.200
Please enter the IP subnet mask (A.B.C.D or /nn): 255.255.255.0
Step 5:
Finally, set up the default gateway.Please enter the IP address of the gateway
from which this network is reachable.[0.0.0.0]: 10.1.1.1