Setup Guide

94 入門指南
Dell 簡易安裝精靈主控台範例
下列範例含有提示的順序，以及和執行範例 Dell 簡易安裝精靈工作階段相關
聯的回應
( 使用上方列出的輸入值 ) 。
在切換器完成
POST 測試後以及開機之後，螢幕上會出現下列對話：
Unit 1 - Waiting to select management unit)>
Applying Global configuration, please wait...
Welcome to Dell Easy Setup Wizard
The Setup Wizard guides you through the initial switch configuration, and
gets you up and running as quickly as possible.You can skip the setup wizard,
and enter CLI mode to manually configure the switch.You must respond to
the next question to run the setup wizard within 60 seconds, otherwise the
system will continue with normal operation using the default system
configuration.Note: You can exit the setup wizard at any point by entering
[ctrl+z].
Would you like to run the setup wizard (you must answer this question within
60 seconds)?[Y/N] y
Step 1:
The system is not set up for SNMP management by default.To manage the
switch using SNMP (required for Dell Network Manager) you can
。 Set up the initial SNMP version 2 account now.
。 Return later and set up other SNMP accounts.(For more information on
setting up an SNMP version 1 or 3 account, see the user documentation).
Would you like to set up the SNMP management interface now?[Y/N] y
To set up the SNMP management account you must specify the management
system IP address and the “community string” or password that the particular
management system uses to access the switch.The wizard automatically
assigns the highest access level [Privilege Level 15] to this account.You can
use Dell Network Manager or other management interfaces to change this
setting, and to add additional management system information later.For more
information on adding management systems, see the user documentation.
To add a management station:
Please enter the SNMP community string to be used.[public]: public