Users Guide

Managing General System Settings 497
Viewing Slot Information
Use the following commands to view information about Slot 0 and its
support.
Configuring PoE Settings
This section applies to (Dell EMC Networking N1108P-ON/ N1124P-ON/
N1148P-ON, N1524P/N1548P, N2024P/N2048P/N2128PX-ON, N2224PX-
ON/N2248PX-ON, N3024EP-ON/N3000/N3132PX-ON Only)
Use the following commands to configure PoE information.
Command Purpose
show slot Display status information about the expansion slots.
show supported cardtype Display information about the modules the switch
supports.
Command Purpose
configure Enter Global Configuration mode.
power inline usage-threshold
threshold [unit unit-id]
Specify the maximum usage for PoE power on the
switch or the specified stack unit. The threshold
variable (range: 1–99%) is a percentage of total
system power.
power inline management
[unit unit-id] {class | static |
dynamic}
Set the power-management mode for the switch or
the specified stack unit. Static power management
is not available on the N2200PX-ON switch.