Administrator Guide

Switch Management Commands 1863
Syntax
boot host auto-save
no boot host auto-save
Default Configuration
The default value is disabled.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines
Example
console#
console#configure
console(config)#boot host auto-save
console(config)#no boot host auto-save
boot host dhcp
Use the boot host dhcp command in Global Configuration mode to enable
Auto-Install and Auto Configuration on the switch. When a switch boots
with a saved startup configuration that includes this command, the Auto-
Install process is triggered. Use the no form of this command to disable Auto-
Install on the next reboot if the reboot occurs with a saved startup
configuration. If you give this command while the Auto-Install process is
running, the Auto-Install process terminates. The Auto-Install process has an
internal timer that retries failed installations for ten minutes.
Syntax
boot host dhcp
no boot host dhcp
Default Configuration
The default value is Enabled.