Administrator Guide

Switch Management Commands 2001
show ip address-conflict
Use the show ip address-conflict command in User Exec or Privileged Exec
mode to display the status information corresponding to the last detected
address conflict.
Syntax
show ip address-conflict [vrf vrf-name]
• vrf-name—The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec mode, Global Configuration mode and all
Configuration submodes
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N3100-ON/N4000 series
switches.
The command provides the following information.
Term Description
Address Conflict
Detection Status
Whether the switch has detected an address conflict on any IP
address. Set to Conflict Detected if detected, No Conflict
Detected otherwise.
Last Conflicting IP
Address
The IP address that was last detected as conflicting on any
interface.
Last Conflicting
MAC Address
The MAC Address of the conflicting host that was last detected
on any interface.