Administrator Guide

Layer 2 Switching Commands 814
User Guidelines
This command has no user guidelines.
Example
The following example displays the Protocol-Based VLAN information for
either the entire system.
console#show port protocol all
Group
Group Name ID Protocol(s) VLAN Interface(s)
--------------- ----- ---------- ---- ------------
test 1 IP 1 gi1/0/1
show switchport ethertype
Use the show switchport ethertype to display the configured Ethertype for
each interface.
Syntax
show switchport ethertype [ interface interface-id | all ]
• interface-id—A physical interface or port channel.
• all—All interfaces.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec mode and all Show modes
User Guidelines
Up to three additional TPIDs can be configured. The 802.1Q TPID is pre-
configured in the system and may not be removed.
It is not possible to configure an inner VLAN TPID value other than 0x8100.