Users Guide

DHCPv6 Server Settings 1443
Configuring the DHCPv6 Server and Relay (CLI)
This section provides information about the commands used for configuring
and monitoring the DHCP server and address pools. For more information
about the commands, see the Dell EMC Networking N1100-ON, N1500,
N2000, N2100-ON, N3000E-ON, and N3100-ON Series Switches CLI
Reference Guide at www.dell.com/support.
Configuring Global DHCP Server and Relay Agent Settings
Use the following commands to configure settings for the DHCPv6 server.
Configuring a DHCPv6 Pool for Stateless Server Support
Use the following commands to create a pool and configure pool parameters
for DHCPv6 clients that obtain IPv6 network information dynamically.
Command Purpose
configure Enter Global Configuration mode.
service dhcpv6 Enable the DHCPv6 server.
ipv6 dhcp relay-agent-
info-opt option
Configure a number to represent the DHCPv6 Relay
Agent Information Option.
The option parameter is an integer from 54–65535.
ipv6 dhcp relay-agent-
info-remote-id-subopt
suboption
Configure a number to represent the DHCPv6 remote-ID
sub-option
The suboption parameter is an integer from 1–65535.
exit Exit to Privileged Exec mode.
show ipv6 dhcp Verify the global DHCPv6 server configuration.
Command Purpose
configure Enter Global Configuration mode.
ipv6 dhcp pool name Create a DHCPv6 pool and enter DHCPv6 pool
configuration mode.
dns-server ipv6-address Set up to eight IPv6 DNS server addresses to provide to a
DHCPv6 client by the DHCPv6 server.