Users Guide
238 Stacking
The following is the output on Dell EMC Networking N1500 Series
switches:
console#show supported switchtype
SID Switch Model ID
--- --------------------------------
1 N1524
2 N1524P
3 N1548
4 N1548P
2
Preconfigure the switch (SID = 2) as member number 2 in the stack.
console#configure
console(config)#stack
console(config-stack)#member 2 2
console(config-stack)#exit
console(config)#exit
3
Confirm the stack configuration. Some of the fields have been omitted
from the following output due to space limitations.
console#show switch
Management Standby Preconfig Plugged-in Switch Code
SW Status Status Model ID Model ID Status Version
-- ------ ------ -------- -------- ------ -------
1 Mgmt Sw N3048 N3048 OK 6.0.0.0
Preconfigured switches may be removed from the configuration using the no
member command. Only switches that are not active members of the stack
may be removed.