Administrator Guide

Layer 3 Routing Commands 1590
show ip traffic
Use the show ip traffic command in User EXEC mode to display IP statistical
information of the software IP stack. Refer to RFC 1213 for more information
about the fields that are displayed.
Syntax
show ip traffic [vrf vrf-name ]
• vrf-name —The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes, Configuration mode and all
Configuration submodes
User Guidelines
This command displays statistics for the software IP stack, not the hardware
routing information.
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N4000 series switches.
Example
The following example displays IP route preferences.
console>show ip traffic
IpInReceives................................... 24002
IpInHdrErrors.................................. 1
IpInAddrErrors................................. 925
IpForwDatagrams................................ 0
IpInUnknownProtos.............................. 0
IpInDiscards................................... 0
IpInDelivers................................... 18467
IpOutRequests.................................. 295
2CSNXXX_SWUM204.book Page 1590 Monday, January 25, 2016 1:25 PM