Administrator Guide

Layer 3 Routing Commands 1753
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
A value of 1 is the highest router priority. A value of 0 indicates that the
interface is not eligible to become the designated router on this network.
Example
The following example sets the OSPF retransmit Interval for VLAN 15 at 50
seconds.
console(config-if-vlan1)#ip ospf retransmit-interval 50
ip ospf transmit-delay
Use the ip ospf transmit-delay command in Interface Configuration mode to
set the OSPF Transit Delay for the specified interface. Use the no form of the
command to return the delay to the default value.
Syntax
ip ospf transmit-delay seconds
no ip ospf transmit-delay
• seconds — Sets the estimated number of seconds it takes to transmit a link
state update packet over this interface. (Range: 1–3600 seconds)
Default Configuration
1 is the default number of seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
2CSNXXX_SWUM204.book Page 1753 Monday, January 25, 2016 1:25 PM