Administrator Guide

Layer 3 Routing Commands 1754
Example
The following example sets the OSPF Transit Delay for VLAN 15 at 20
seconds.
console(config-if-vlan1)#ip ospf transmit-delay 20
log adjacency-changes
Use the log adjacency-changes command in OSPFv2 Router Configuration
mode to enable logging of OSPFv2 neighbor state changes.
Use the no form of the command to disable state change logging.
Syntax
log-adjacency-changes [detail]
no log-adjacency-changes [detail]
• detail —(Optional) When this keyword is specified, all adjacency state
changes are logged. Otherwise, OSPF only logs transitions to FULL state
and when a backwards transition occurs.
Default Configuration
Adjacency changes are not logged by default.
Command Mode
OSPFv2 Router Configuration mode
User Guidelines
State changes are logged with INFORMATIONAL severity.
max-metric router-lsa
Use the max-metric router-lsa command in router OSPF Global
Configuration mode to configure OSPF to enable stub router mode.
To disable stub router mode, use the no max-metric router-lsa command in
OSPFv2 Global Router Configuration mode.
2CSNXXX_SWUM204.book Page 1754 Monday, January 25, 2016 1:25 PM