Administrator Guide

Layer 3 Routing Commands 1816
Example
The following example configures a hello interval of 20 seconds for the OSPF
virtual interface on the virtual interface identified by area 1
and its neighbor.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2 hello-interval 20
area virtual-link retransmit-interval
Use the area virtual-link retransmit-interval command in Router OSPFv3
Configuration mode to configure the retransmit interval for the OSPF virtual
interface on the virtual interface identified by
areaid and neighbor .
Syntax
area areaid virtual-link neighbor retransmit-interval seconds
no area areaid virtual-link neighbor retransmit-interval
• areaid — Valid OSPFv3 area identifier.
•
neighbor — Router ID of neighbor.
•
seconds — Retransmit interval. (Range: 0-3600)
Default Configuration
5 is the default value for seconds .
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the retransmit interval of 20 seconds for
the OSPF virtual interface on the virtual interface identified by area 1 and its
neighbor.
(config)#ipv6 router ospf
(config-rtr)#area 1 virtual-link 2 retransmit-interval 20
2CSNXXX_SWUM204.book Page 1816 Monday, January 25, 2016 1:25 PM