Administrator Guide

Layer 3 Routing Commands 1838
Example
The following example configures the OSPFv3 protocol to allow
redistribution of routes to connected devices.
console(config)#ipv6 router ospf
console(config-rtr)#redistribute connected
router-id
Use the router-id command in Router OSPFv3 Configuration mode to set a
4-digit dotted-decimal number uniquely identifying the Router OSPF ID.
Syntax
router-id router-id
• router-id — Router OSPF identifier. (Range: 0-4294967295)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets a 4-digit dotted-decimal number identifying the
Router OSPF ID as 2.3.4.5.
console(config)#ipv6 router ospf
console(config-rtr)#router-id 2.3.4.5
show ipv6 ospf
Use the show ipv6 ospf command in Privileged Exec mode to display
information relevant to the OSPF router.
2CSNXXX_SWUM204.book Page 1838 Monday, January 25, 2016 1:25 PM