Administrator Guide

Layer 3 Routing Commands 1856
• neighbor-id — Router ID of neighbor.
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec mode, Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF Virtual Interface information for
area 1 and its neighbor.
console#show ipv6 ospf virtual-link 1 1.1.1.1
Area ID........................................ 1
Neighbor Router ID............................. 1.1.1.1
Hello Interval................................. 10
Dead Interval.................................. 40
Iftransit Delay Interval....................... 1
Retransmit Interval............................ 5
State.......................................... point-to-point
Metric......................................... 10
Neighbor State................................. Full
show ipv6 ospf virtual-link brief
Use the show ipv6 ospf virtual-link brief command in Privileged Exec mode
to display the OSPFV3 Virtual Interface information for all areas in the
system.
Syntax
show ipv6 ospf virtual-link brief
Default Configuration
This command has no default configuration.
2CSNXXX_SWUM204.book Page 1856 Monday, January 25, 2016 1:25 PM