Administrator Guide

Switch Management Commands 2194
Example-Stack Port Errors
console(config-stack)#initiate failover
Warning! Stack errors detected on the following interfaces:
Interface Error Count
---------------- ----------------
Gi1/0/1 12
Gi1/0/3 22
NSF Status: Not synchronized
Stack port errors or lack of NSF synchronization may indicate a non-redundant
stack topology exists. Fail-over on a non-redundant topology may cause the
stack to split!
Management unit will be reloaded.
Are you sure you want to failover to the backup unit? (y/n)
load-interval
Use this command to load the interface utilization measurement interval.
Use the no form of this command to reset the duration to the factory default
value.
Syntax
load-interval time
no load-interval
• time — The number of seconds after which interface utilization is measured
periodically. The time has to be a multiple of 30. (Range 30-600 seconds)
Default Configuration
The default interval is 300 seconds.
Command Modes
Interface Configuration mode, Interface Range Configuration mode, Port
Channel Configuration mode, Port Channel Range Configuration mode.
User Guidelines
This command has no user guidelines.
2CSNXXX_SWUM204.book Page 2194 Monday, January 25, 2016 1:25 PM