Administrator Guide

Switch Management Commands 2206
• stack–member–number —The stack member to be reloaded.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
If no unit is specified, all units are reloaded.
Examples
Example-Reloading the Stack
The following example displays how to reload the stack.
console#reload 1
Management switch has unsaved changes.
Would you like to save them now? (y/n)n
Configuration Not Saved!
Are you sure you want to reload the switch? (y/n) y
Reloading management switch 1.
Example-Stack Port Errors
The following example shows stack port errors detected by the command.
console#reload
Management switch has unsaved changes.
Are you sure you want to continue? (y/n)
Warning! Stack port errors detected on the following interfaces:
Interface Error Count
---------------- ----------------
Gi1/0/1 12
Gi1/0/3 22
Stack port errors may indicate a non-redundant stack topology exists. Fail-
over on a non-redundant topology may cause the stack to split!
Are you sure you want to reload the stack? (y/n)
2CSNXXX_SWUM204.book Page 2206 Monday, January 25, 2016 1:25 PM