Administrator Guide

Layer 2 Switching Commands 548
Example
console(config)#ipv6 mld snooping querier vlan 10
ipv6 mld snooping querier address
Use the ipv6 mld snooping querier address command to set the global MLD
Snooping Querier address. Use the no form of this command to reset the
global MLD Snooping Querier address to the default.
Syntax
ipv6 mld snooping querier address prefix [ /prefix-length ]
no ipv6 mld snooping querier address
• prefix — An IPv6 address prefix.
•
prefix-length — Designates how many of the high-order contiguous bits of
the address make up the prefix.
Default Configuration
There is no global MLD Snooping Querier address configured by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 mld snooping querier address Fe80::5
ipv6 mld snooping querier election participate
Use the ipv6 mld snooping querier election participate command to enable
the Snooping Querier to participate in the Querier Election process when it
discovers the presence of another Querier in the VLAN. When this mode is
enabled, if the Snooping Querier finds that the other Querier's source address
is numerically lower than the Snooping Querier's address, it stops sending
2CSNXXX_SWUM204.book Page 548 Monday, January 25, 2016 1:25 PM