Administrator Guide

Security Commands 1006
Default Configuration
Captive portal only monitors port 80 by default.
Command Mode
Captive Portal Configuration mode
User Guidelines
The port number should not be set to a value that might conflict with other well-
known protocol port numbers used on this switch.
Example
console(config-CP)#http port 32768
console(config-CP)#no http port
https port
Use the https port command to configure an additional HTTPS port for
captive portal to monitor. Use the “no” form of this command to remove the
additional HTTPS port.
Syntax
https port port-num
no https port
• port-num —The port number on which the HTTPS server listens for
connections (Range: 1025–65535).
Default Configuration
Captive portal listens on port 443 by default.
Command Mode
Captive Portal Configuration mode.
User Guidelines
The port number should not be set to a value that might conflict with other well-
known protocol port numbers used on this switch.
2CSNXXX_SWUM204.book Page 1006 Monday, January 25, 2016 1:25 PM