Administrator Guide

Security Commands 1012
locale
The locale command is not intended to be a user command. The
administrator must use the Web UI to create and customize captive portal
web content. This command is primarily used by the show running-config
command and process as it provides the ability to save and restore
configurations using a text based format.
Syntax
locale web-id
• web-id —The locale number (Range: Only locale 1 is supported)
Default Configuration
Locale 1 is configured by default.
Command Mode
Captive Portal Instance mode.
User Guidelines
Captive Portal supports 3 locales per configuration.
name (Captive Portal)
Use the name command to configure the name for a captive portal
configuration. Use the no form of this command to remove a configuration
name.
Syntax
name cp-name
no name
• cp-name —CP configuration name (Range: 1–32 characters).
Default Configuration
Configuration 1 has the name “Default” by default. All other configurations
have no name by default.
2CSNXXX_SWUM204.book Page 1012 Monday, January 25, 2016 1:25 PM