Administrator Guide

Audio Visual Bridging Commands 1136
Syntax
dot1as timeout announce expiries
no dot1as timeout announce
• expiries —The number of expriries with no received announce message on
which the master is considered to be no longer transmitting. The range is
2–255.
Default Configuration
By default, the number of expiries is set to 3.
Command Mode
Interface Configuration
User Guidelines
IEEE 802.1AS must also be enabled globally as well as on an interface to
become operational.
Command History
Introduced in version 6.2.0.1 firmware.
Example
This example configures interface Gi1/0/4 to delay expiring the master clock,
if found, for up to 5 announce intervals.
console(config-if-Gi1/0/4)#dot1as timeout announce 5
console(config-if-Gi1/0/4)#show dot1as interface gi1/0/4
AS Interface Admin Mode................... Enabled
AS Capable................................ No
Is Measuring Delay............................. No
Propagation Delay.............................. 0
Port Role...................................... Disabled
PDELAY Threshold............................... 2500
PDELAY lost responses allowed.................. 3
Neighbor Rate Ratio............................ 0
Initial Sync Interval.......................... -3
Current Sync Interval.......................... -3
Initial Pdelay Interval........................ 3
Current Pdelay Interval........................ 0
2CSNXXX_SWUM204.book Page 1136 Monday, January 25, 2016 1:25 PM