Administrator Guide

Data Center Technology Commands 1189
• switch controllers —Show information about configured controllers
•
switch flows —Show information regarding flows
•
switch groups —Show information regarding OpenFlow groups
•
switch tables —Show information regarding the switch tables
Default Configuration
When invoked with no parameters, the show openflow command shows
summary information regarding OpenFlow.
Command Mode
Privileged Exec and Global Configuration
User Guidelines
OpenFlow operates on the stack master only. Flows may not be configured on
stack members. Failover to the stack standby unit is not supported.
OpenFlow should only be enabled on stand-alone switches and should not be
enabled on stacks of switches. This restriction is not enforced.
The command has the following output.
Parameter Description
Administrative Mode The OpenFlow feature administrative mode set by the
‘openflow enable’ command.
Administrative Status The operational status of the OpenFlow feature. Although
the feature may be administratively enabled, it could be
operationaly disabled due to various reasons.
Disable Reason If the OpenFlow feature is operartionaly disabled then this
status shous the reason for the feature to be disabled.
IP Address IPv4 Address assigned to the feature. If the IP address is
not assigned then the status is ‘None’.
IP Mode IP mode assigned by the ‘openflow ip-mode’ command.
The IP Mode can be “Auto”, “Static” or “ServicePort IP”
Static IP Address Static IP address assigned by the ‘openflow static-ip-
address’ command.
Network MTU Maximum network packet size excluding the VLAN Tag.
2CSNXXX_SWUM204.book Page 1189 Monday, January 25, 2016 1:25 PM